The process of pre-treatment precipitates the bulk of water and mud solids in the septic tank and thereby significantly increase the life filter element. Stage 5 Final filtration of the fuel remaining solids and water filter element is made of special material. Elements are supplied with different values cells. Refined fuel leaves the filter through outlet C or D (unused plugged attached cover) Backwash off the engine. Remove the bolt on the depressurization of the filter cover. Open the drain valve.
Clean fuel, located above the filter element at the top of the filter falls back down and promoet element of water droplets and dirt particles. Necessary to produce discharge from the filter until wash the dirt from the filter. Then close the valve and, if necessary, removing the lid, fill the fuel filter to remove air from the fuel system. Tighten the bolt and let go of depressurization of the engine. If there is loss of power, replace the filter element. In any case, the filter element change is required at least 1 time per year. Separ fuel filter 2000 can be installed on any vehicle (truck and passenger car, bus, construction or agricultural machine) with a diesel engine. Separ 2000 is available as a fuel heater for 12 and for 24-volt network.
The all-new multi-level system guarantees 100% solution clean fuel from water and dirt. In addition to the undoubted benefits of Separ-2000 are high capacity, long life filter element, ease of installation and maintenance. For areas with low temperatures, especially in cases where the possible long simple transport the engine shut off at t With Separ-2000 fuel system of your car will be protected.